Bearing Preload (Differential)

Bearing preload (Differential)
Measure the preload as follows.





1. Set the differential assembly into the clutch housing.





2. Install the transaxle case onto the clutch housing.
Tightening torque: 14 - 19 ft. lbs. (19 - 26 Nm, 1.9 - 2.6 kg-m)





3. Install a SST (OK900 175 AAO) to the differential side gear, through the transaxle case.





4. Measure the bearing preload.
Preload: 104 - 144 ft. lbs. (137 - 196 Nm, 14 - 20 kg-m)
5. If not as specified, readjust the bearing preload.
6. Remove the SST (OK130 322 020).
7. Remove the transaxle case and the differential assembly.