Condenser Fan Does Not Operate
Step 1: Check condenser fan operation1. Disconnect condenser fan connector G-11.
2. Apply 12 V to the terminal 1 (L/B) and ground terminal 2(B) and verify that condenser fan operates.
3. If condenser fan does not operate, replace condenser fan.
4. If condenser fan operates, go to step 2.
Step 2: Check voltage at condenser fan
1. Verify that condenser fan connector G-11 is disconnected.
2. Run engine at idles.
3. Turn the A/C and blower switches to ON position.
4. Check for voltage at following terminal wire of wiring harness connector G-11.
Inspection
Condenser fan relay
1. Disconnect condenser fan relay from fuse box in engine compartment.
2. Check for continuity between following terminals of the relay.
3. If not as specified, replace the relay.
4. If correct, go to next step.
5. Apply 12 V to the terminal 85 and ground the terminal 86.
6. Check for continuity between terminals 87 and 30.
7. If not as specified, replace the relay.
8. If relay is OK, go to step 3.
Step 3: Check voltage at condenser fan relay
1. Verify that condenser fan relay is disconnected.
2. Run engine at idles.
3. Turn the A/C and blower switches to ON position.
4. Check for voltage at following terminal of condenser fan relay connector G-10.
5. Check for voltage between terminal 2 (G/R) and following terminal of condenser fan relay connector G-10.
Step 4: Check voltage at condenser fan
1. Verify that condenser fan connector G-11 is disconnected.
2. Run engine at idles.
3. Turn the A/C and blower switches to ON position.
4. Check for voltage at following terminal wire of wiring harness connector G-11.