Inside Assembly

REMOVAL




1. Disconnect negative battery cable.
2. Remove three screws and thirteen fasteners from trunk lid trim.

3. Remove back panel molding assembly.
1. Disconnect electrical connector.




2. Remove one screw from outside of trunk lid.




3. Remove thirteen nuts from trunk lid.




4. Remove four screws from light assembly.




INSTALLATION
1. Position light assembly on back panel molding assembly.
2. Install four screws on light assembly.
3. Install back panel molding assembly
1. Install thirteen nuts on trunk lid.
2. Install one screw on outside of trunk lid.
3. Connect electrical connector.

4. Install three screws and thirteen fasteners on trunk lid trim.
5. Connect negative battery cable.