Center Panel Trim

REMOVAL
1. Remove console.




1. Unfasten rear cover from console.




2. Remove two mounting screws from front cover.
3. Disconnect electrical connector.
4. Remove five mounting screws from console.

2. Unfasten center panel cover and then disconnect electrical connector from rear of center panel trim.

3. Remove radio.
1. Remove four screws from radio.
2. Disconnect electrical connector and antenna cable from rear of radio.




4. Remove two mounting screws and then disconnect electrical connector from rear of lower LH cover.
5. Remove lower RH cover.




1. Remove two grommet from glove box assembly.




2. Remove two screws and one nut from top of lower RH cover.
3. Remove two bolts from bottom of lower RH cover.




6. Remove center panel.
1. Remove five screws from center panel.
2. Disconnect electrical connector from rear of center panel.




INSTALLATION
1. Install center panel.
1. Connect electrical connector.
2. Install five screws on center panel.

2. Install lower RH cover.




1. Install two bolts on bottom of lower RH cover.
2. Install two screws and one nut on top of lower RH cover.




3. Install two grommet on grove box assembly.




3. Install two mounting screws and then connect electrical connector on rear of lower LH cover.

4. Install radio.
1. Install four screws on radio.
2. Connect electrical connector and antenna cable on rear of radio.

5. Fasten center panel cover and then connect electrical connector on rear of center panel trim.




6. Install console.
1. Position console and install five mounting screws.
2. Connect electrical connector.
3. Install two mounting screws on front cover.
4. Fasten rear cover to console.