Inspection

NOTE: For models with disc type rear brakes, refer to Disc Brake System.





1. Raise and suitably support rear of vehicle.
2. Remove rear wheels and release parking brake.
3. Using an impact driver, remove two mounting screws holding brake drum. Remove drum.

NOTICE: If brake drum is difficult to remove, thread two 8 mm jacking bolts into two threaded holes provided on drum face and tighten evenly.

4. Inspect wheel cylinders for brake fluid leaks.
5. Measure lining thickness. Replace both linings if either is less than specification.

Minimum lining thickness: 0.04 inch (1.0 mm)

6. Inspect lining for cracks, uneven wear or oil contamination. Repair or replace as necessary.





7. Measure drum inside diameter. Replace drum if diameter is greater than specification.

Maximum diameter: 7.87 inch (200 mm)

8. Inspect drums for cracks, grooves or uneven wear. Resurface or replace as necessary.





9. Verify new or repaired drum-to-shoe contact.