Overhaul

DISASSEMBLY





1. Remove oil seal from front wheel hub.
2. Remove front wheel hub assembly with suitable tool.





3. Remove retaining ring.

NOTICE: If the bearing inner race remains on wheel hub, grind a section of inner race until approximately 0.5 mm (0.020 in) remains. Remove race with a chisel.





4. Remove wheel bearing with suitable tool.

NOTICE:
a) Do not remove dust shield unless necessary.
b) Do not reuse dust shield if removed.





5. Mark relative positions of dust shield and knuckle for proper reassembly.





6. Remove dust shield with a chisel.

NOTICE:
a) Do not remove wheel studs unless necessary.
b) Do not reuse wheel studs if removed.





7. Remove wheel studs with a press.

ASSEMBLY





1. Press in new wheel studs.





2. Mark new dust shield to match the removed dust shield.
3. Align mark on new dust shield with knuckle.





4. Install new dust shield with suitable tool.





5. Install new wheel bearing with suitable tool.





6. Install front wheel hub assembly with suitable tool.

NOTICE:
a) Use a new oil seal, and apply grease to seal.
b) Install oil seal so that it is flush with knuckle.





7. Install new oil seal with SST (OK993 331016).