Assembly

1. Make sure that all parts are clean and all cleaning solvents have been removed.
2. Coat all internal parts with clean brake fluid.
3. Install internal parts as shown in diagram.
4. Install steel ball, bleeder screw and rubber cap.
5. Install dust boots over each end of the cylinder.
6. Mount cylinder on backing plate and install the two bolts.

Tightening torque: 7 - 9 ft. lbs. (10 - 13 Nm)

7. Connect brake line. Tighten the brake line flare nuts.

Tightening torque: 9 - 16 ft. lbs. (12 - 22 Nm,)

8. Install brake shoe assembly.