Installation

1. Mount a new or repaired rotor on hub and fasten with two mounting screws.
2. Mount the supporting plate with two hex-head bolts.

Tightening torque: 33 - 49 ft. lbs. (45 - 67 Nm)

3. Connect the brake hose to the caliper using a flare nut wrench.

Tightening torque: 9 - 13 ft. lbs. (13 - 18 Nm)

4. Position brake pads in caliper cavity and install caliper onto supporting plate.
5. Lubricate and install two bolts and bushings, and tighten bolts to specification.

Tightening torque: 19 - 21 ft. lbs. (26 - 28 Nm)

6. Install caps.
7. Bleed system.
8. Inspect system for any leaks.