Installation
WarningFuel is explosive. When working on fuel system, make sure to supply adequate ventilation to the work area. Do not smoke, and keep sparks and open flames away.
1. Raise vehicle.
2. Install rollover valve to fuel tank.
3. Install and tighten four bolts for rollover valve.
Tightening torque: 7.7-12.2 ft lb (10.8-16.7 Nm)
4. Remove protective caps from fuel tank ports.
5. Place fuel tank on lifting device and carefully raise fuel tank assembly into correct position.
6. Reconnect canister close valve connector.
7. Reconnect joint hose to fuel tank and tighten clamp.
8. Reconnect two fuel hoses to fuel tank.
Notice: Push evaporative hose onto fuel tank fitting at least 1.0 inch (25 mm). Push fuel filler hoses onto fuel tank and filler pipes at least 1.4 inches (35 mm).
9. Install fuel tank straps and tighten two bolts.
Tightening torque: 32-44 ft lb (43-61 Nm)
10. Install insulator and tighten bolts.
11. Lower vehicle.
12. Reconnect two fuel hoses to fuel delivery module.
13. Install rubber grommet and wires onto access cover.
14. Install access cover and tighten three screws.
Tightening torque: 7.7-12.2 ft lb (10.8-16.7 Nm)
15. Reconnect two connections to fuel delivery module.
16. Position wires correctly and secure to floor with tape.
17. Reinstall rear seat cushion.
18. Reconnect negative battery cable.