Pre-Inspection

PREPARATION





SST

PRE-INSPECTION

Clutch Operation
1. Set the reverse/forward clutch assembly onto the oil pump.





2. Check the clutch operation by applying compressed air through the fluid passages shown.

Applied air pressure: 57 psi (392 kPa) maximum

Clutch Clearance
Reverse Clutch





1. Measure the clearance between the retaining plate and the snap ring.

Clearance: 0.039 - 0.051 inch (1.0 - 1.3 mm)

2. If not as specified, replace parts as necessary.

Forward Clutch





1. Measure the clearance between the retaining plate and the snap ring.

Clearance: 0.039 - 0.047 inch (1.0 - 1.2 mm)

2. If not as specified, replace parts as necessary.

Coasting Clutch


1. Remove the snap ring, retaining plate, drive plates, driven plates, and dished plate of the forward clutch.





2. Measure the clearance between the retaining plate and the snap ring.

Clearance: 0.039 - 0.047 inch (1.0 - 1.2 mm)

3. If not as specified, replace parts as necessary.