Torque Converter

NOTE: The torque converter is welded together and cannot be disassembled.

INSPECTION
1. Check the outer surface of the converter for damage or cracks and replace it if necessary.
2. Check whether there is any rust on the pilot hub of the converter or on the boss. If there is any, remove it completely.





3. Measure the bushing of the converter boss. Replace the converter assembly if the bushing is worn.

Bushing inner diameter:
Standard: 2.088 inch (53.030 mm)
Maximum: 2.090 inch (53.075 mm)

WASHING INSIDE THE CONVERTER
1. Drain any ATF remaining in the converter.
2. Pour in ATF 0.5 US qts. (0.5 liters).
3. Shake the converter to clean the inside. Pour out the ATF.
4. Pour in ATF.





5. Shake the converter to clean the inside. Pour out the ATF.

NOTICE: Replace the torque converter if it contains any metallic particles.