After Repair Procedure

After Repair Procedure

1. Diagnostic trouble codes may be erased by disconnecting the negative battery cable for at least twenty seconds. then reconnecting the negative battery cable or by using a scan tool.
2. Locate the OBD-II DLC (data link connector) and plug an OBD-II scan tool into it.
3. Turn the ignition switch ON.
4. Start and warm engine, then run at 2,000 rpm for three minutes.
5. Following the scanner manufacture's instructions, verify that no DTC's (diagnostic trouble codes) are recorded. If DTC's are recorded, refer to DIAGNOSTIC TROUBLE CODES.