Inspection

NOTE: Inspect all parts and repair or replace as necessary.

DRIVE PLATES





1. Measure the facing thickness in three places, and determine the average of the three readings.

Standard: 0.063 inch (1.6 mm)
Minimum: 0.055 inch (1.4 mm)

2. If not within specification, replace the drive plate(s).

SPRING AND RETAINER ASSEMBLY





1. Measure the spring free length and check for deformation.

Free length of spring: 0.563 inch (14.3 mm)

2. If not within specification, replace the spring and retainer assembly.