Production Date 7/24/96 to 2/17/97

1. Completely lower the window and remove the door trim.

2. Remove (and keep) the three (3) screws securing the outside mirror to the door.

3. Remove the mirror from the door and disconnect the electrical connector (if equipped).





4. Pull the door glass run down at the center, then continue to pull the door glass run out of the door window frame.





5. Insert the top rear corner of the new door glass run into the window frame and push the rear edge into place.

NOTICE
Make sure the upper rear corner is fully seated in the door window frame.





6. Push the bottom of the front vertical section of the door glass run down into the door.





7. Push the door glass run down until the top front corner is aligned with the top front corner of the door window frame.





8. Push the lower rear portion of the door glass run into the door, and then push the rear vertical section onto the door window frame.





9. Push the front vertical section of the door glass run onto the door window frame.

10. Re-connect the outside mirror electrical connector (if equipped) then re-install the mirror to the door using the three (3) existing screws.

11. Cycle the window up and down several times to ensure smooth/proper operation.