Transmission Position Sensor/Switch: Adjustments

Description:

1. Disconnect the negative battery cable.
2. Remove the battery, air cleaner assembly, and battery carrier.
3. Remove the nut and clip. Disconnect the selector cable.
4. Rotate the manual shaft to the N position.
5. Disconnect the transaxle range switch connector.
6. Loosen the transaxle range switch mounting bolts.
7. Connect the ohmmeter between terminals 5 and 7.
8. Adjust the switch to the point where there is continuity between the terminals.
9. Tighten the transaxle range switch mounting bolts.

Tightening torque: 70 - 95 in lb. (7.9 - 10.7 Nm)

10. Verify that the selector lever range position and transaxle range switch correspond.
11. Connect the transaxle range switch connector.
12. Connect the selector cable and install the nut and a new clip.

Tightening torque: 24 - 33 ft lb. (32 - 46 Nm)

13. Install the battery carrier, air cleaner assembly, and battery.