Automatic Transmission

Description:

ADJUSTMENT
1. Disconnect the connector from the throttle position (TP) sensor.
2. Connect an ohmmeter between the throttle position sensor terminals 1(E) and 2 (IDL).
3. Loosen the two attaching screws.
4. Insert a 0.010 in (0.25 mm) feeler gauge between the throttle stop screw and the stop lever.
5. Rotate the throttle position (TP) sensor clockwise approximately 30 degrees, then rotate it back counterclockwise until there is continuity.
6. Replace the feeler gauge with a 0.016 in (0.4 mm) gauge and verify that there is no continuity.
7. If there is continuity, repeat Steps 4 through 6.
8. Tighten the two attaching screws.

Tightening torque: 14 - 21 in lb. (1.6 - 2.4 Nm)

NOTICE: Do not move the throttle position (TP) sensor from the set position when tightening the screws.

9. Open the throttle valve fully and verify that the resistance between the throttle sensor terminals 1(E) and 3(Vt) is approximately 5,000 ohms.