Front Door Window Glass: Service and Repair

Glass Replacement

1. Remove the front door trim.
2. Remove the glass mounting plug hole (A).

CAUTION:
- Take care not to drop to glass and scratch the glass surface.

3. Carefully adjust the glass (B) until you can see the bolts, then loosen them. Separate the glass from the glass run and carefully pull the glass out through the window slot.

Tightening torque :
8.8 - 11.8 N.m (0.9 - 1.2 kgf.m, 6.5 - 8.7 lb-ft)




4. Installation is the reverse of removal.

NOTE:
- Roll the glass up and down to see if it move freely without binding.
- Adjust glass position as needed.
- Replace ant damaged clips.
- Make sure the door locks/unlocks and opens/closes properly.