Output Speed Sensor

Removal

1. Remove the battery and the battery tray.
2. Remove the under cover (A).




3. Replace new gasket and the plug after draining the automatic transaxle fluid by removing the drain plug.

4. Remove the valve body cover (A) and eyebolt (B).

Tightening torque:
(A) 9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)
(B) 34.3 - 44.1 N.m (3.5 - 4.5 kgf.m, 25.3 - 32.6 lb-ft)

CAUTION:
The gasket of the eyebolt use new one.

NOTE:
Remove installation bolts in the engine room first and then remove others under the vehicle.




5. Remove the plate and the detend spring (A) after removing the bolt.

Tightening torque:
24.5 - 35.3 N.m (2.5 - 3.6 kgf.m, 18.1 - 26.0 lb-ft)




6. Remove the bolt (3ea) after disconnecting the solenoid valve connector (A) and the oil temperature sensor connector (B).

Tightening torque:
9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)

CAUTION:
Be careful not to damage the harness lock connector.




7. Remove the valve body assembly (A).

Tightening torque:
9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)




8. Disconnect the connector (A) from the main wiring.
9. Remove the input & output speed sensor (B) after removing the bolts (2ea)

Tightening torque:
9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)





Installation

1. Installation is the reverse of removal.

CAUTION:
After replacement or reinstallation procedure of the valve body assembly, must perform procedures below.
- Continue to apply liquid gasket at application points at the valve body cover with Ø2.5mm (0.0984in.) thickness.
Liquid gasket Part name :
Three bond 1281B or LOCTITE FMD-546(P/N : UM010CH046) or equivalent
- Adding automatic transaxle fluid.