Tire Pressure Monitor Receiver / Transponder: Service and Repair

Replacement

NOTE:
When the receiver first arrives for replacement:
1) It will be in Virgin State.
2) It will not be configured for any specific platform.
3) It will not have any sensor ID's memorized.

CAUTION:
It is important to make sure that the correct receiver is used to replace the faulty part i.e. it must be Low Line (95800-1U000) in order to have the correct inflation warning thresholds set.

1. Disconnect vehicle battery (-)cable.
2. Remove the RH luggage side trim.
3. Remove faulty part and fit bracket assembly to new part.




4. Secure new part to vehicle and fit connector.
5. Re-connect battery and turn Ignition on.

Vehicle Name Writing

















VIN Writing