Repair Procedures

Removal

PDM(Power Distribution Module)
1. Disconnect the negative(-) battery terminal.
2. Remove the crash pad lower panel (A).





3. Remove the power distribution module (A) after loosening nuts (2EA).





PDM(Power Distribution Module) Relay
1. Remove the negative(-) battery terminal.
2. Remove the glove box housing.

3. After removing the screws (2EA) and connector, remove PDM relay box (A).






Inspection

PDM Diagnosis With GDS
1. It will be able to diagnose defects of Smart key with GDS quickly. GDS can operates actuator forcefully, input/output value monitoring and self diagnosis.
2. Select model and "Smart key system(Button start)" menu if you want to check PDM.




3. Select "PDM" in the manu.




4. Select "Current Data", if you want to check current data of PDM.
It provides the input/output status of each module.




5. If you want to check PDM data operation forcefully, select "Actuation test".






Installation

PDM(Power Distribution Module)
1. Install the power distribution module.
2. Install the main crash pad.
3. Install the crash pad lower panel.
4. Install the negative(-) battery terminal.

PDM(Power Distribution Module) Relay
1. Install the power distribution module relay box.
2. Install the glove box housing.
3. Install the negative(-) battery terminal.