Fuel Pump: Service and Repair

Removal

1. Release the residual pressure in fuel line .
2. Remove the rear seat .
3. Remove the fuel pump service cover (A).





NOTE:
The wiring in between the fuel pump and the sub fuel sender is fastened to the vehicle. So please separate it before removing the fuel pump service cover in accordance with the procedures below.
1. Remove the sub fuel sender cover and disconnect the sub fuel sender connector .
2. Release the wiring clips (A) under the carpet.




4. Disconnect the fuel pump connector (A) and the fuel tank pressure sensor connector (B).
5. Disconnect the fuel feed tube quick connector (C) and the vapor tube quick-connector (D).




6. Remove locking ring (A) by using the special service tool (B).




7. Disconnector the suction tube (A) at the bottom of the fuel pump, and then remove the fuel pump from the fuel tank.










Installation

1. Installation is reverse of removal.

CAUTION:
Be careful of fuel pump direction when installing (Refer to the groove in the fuel tank).