Console Lamp: Service and Repair

Inspection

Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch.










Removal

1. Disconnect the negative (-) battery terminal.
2. Remove the mounting screws (2EA).
And then remove the overhead console (A).




3. Remove the overhead console lamp (B) from the head lining after disconnecting the sunroof switch connector and map lamp switch connector (A).








4. If the bulb only should be replaced, replace the bulb after removing the lens.

Installation

1. Install the overhead console lamp after connecting the sunroof switch connector and lamp connector.
2. Install the lens after tightening 2 screws.