Repair Procedures

Removal

2WD
1. Remove the connector after removing the rear wheel speed sensor clip.
2. Remove the rear wheel speed sensor.
3. Installation is the reverse of removal.
4WD
1. Remove the rear driveshaft.
2. Disconnect the rear wheel speed sensor connector (A).




3. Remove the rear wheel speed sensor after remove the hub assembly mounting bolts (B).

Tightening torque :
78.5 - 98.1N.m (8.0 - 10.0kgf.m, 57.9 - 72.3lb-ft)

4. Installation is the reverse of removal.