Parking Brake Shoe: Service and Repair

Removal

Parking Brake Shoe
1. Raise the vehicle, and make sure it is securely supported.
2. Remove the rear tire and wheel.
3. Remove the rear brake caliper and Rear disc brake.

4. Remove the parking brake cable (B), after removing the clip (A).




5. Remove the shoe hold down pin (A) and the spring (B) by pressing and rotating the spring.




6. Remove the adjuster assembly (D) and the lower return spring (C).




7. Remove the upper return spring (E) and the brake shoes (F).




8. Remove the operating lever assembly (G).

Installation

Parking Brake Shoe
1. Install the operating lever assembly (G).




2. Install the upper return spring (E) and the brake shoes (F).
3. Install the adjuster assembly (D) and the lower return spring (C).




4. Install the shoe hold down pin (A) and spring (B) by pressing and rotating the spring.




5. Install the parking brake cable (B), then install the clip (A).




6. Install the rear brake disc, then adjust the rear brake shoe clearance.
(1) Remove the plug from the disc.




(2) Rotate the toothed wheel of adjuster by a screw driver until the disc is not moving, and then return it by 5 notches in the opposite direction.
7. Install the brake caliper assembly.
8. Install the tire and wheel, after installing the plug on the disc.