Antenna, Radio: Service and Repair

Inspection

Antenna Cable
1. Remove the antenna jack from the audio unit and antenna.
2. Check for continuity between the center poles of antenna cable.




3. Check for continuity between the outer poles of antenna cable. There should be continuity.




4. If there is no continuity, replace the antenna cable.
5. Check for continuity between the center pole (A) and outer pole (B) of antenna cable. There should be no continuity.




6. If there is continuity, replace the antenna cable.

Removal

1. Remove the rear roof trim.

2. Disconnect the roof antenna feeder cable and connector (A) from the roof antenna.




3. Disconnect the antenna jack (A) and power cable (B).




4. Remove the roof antenna (A) after removing a nut.






Installation

1. Connect the roof antenna cables and connectors.
2. Install the rear roof trim.

NOTE:
- Make sure that the cables and connectors are plugged in properly.
- Check the audio system.