Reassembly

REASSEMBLY (CALIPER)

1. When disassembling the caliper assembly, use a new piston seal and boot.
2. Apply the recommended fluid to the bearing part of the piston seal and piston. Insert the piston seal into grooves inside the caliper, being careful not to twist the seal.





3. Install the piston boot to the piston.Confirm that the concave part of the piston is placed outward and the boot is seated in grooves of the piston completely.




4. Install the piston and boot in the caliper housing. Insert the boot flange in the caliper housing and check that the boot fits in grooves around the piston.
5. Apply the recommended oil to the inside of the locating pin insulator.