Headlamp Bulb - Installation - Export

BULB - BI-HALOGEN HEADLAMP - EXPORT MK49

CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp, the socket or the lamp wiring.

CAUTION: Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb life will result.





1. Reach behind the front lamp unit to access the bulb openings on the back of the lamp housing (1).
2. Align the bulb with the keyed opening on the back of the front lamp unit reflector.
3. Insert the bulb into the reflector opening until the base is firmly seated.
4. Rotate the base clockwise about 30 degrees to lock it into place.
5. Reconnect the lamp wiring connector to the bulb connector receptacle. Be certain that the metal latch tabs of the connector are fully engaged.
6. Reinstall the molded rubber cover (2) over the opening on the back of the front lamp unit housing.
7. Reconnect the battery negative cable.