DRL and Position Lamp Bulb - Installation - Export

BULB - DRL AND POSITION LAMP - EXPORT MK49

NOTE: The following procedure applies only to export vehicles with bi-halogen projector headlamps and Daytime Running Lamps (DRL). This procedure also applies to the position lamp bulb for export markets only. Vehicles equipped with quad halogen headlamps (domestic market only) modulate either the low beam or high beam headlamp bulb to serve as the DRL.





1. Align the base of the bulb with the Daytime Running Lamp (DRL) and position lamp bulb socket (5).
2. Push the bulb straight into the socket until the base is firmly seated.
3. Reach behind the front lamp unit to access the bulb opening on the back of the lamp housing (1).
4. Align the socket and bulb with the keyed opening on the back of the housing.
5. Insert the socket and bulb into the housing until the socket is firmly seated.
6. Rotate the socket clockwise about 30 degrees to lock it into place.
7. Reconnect the Front End Module (FEM) wire harness connector to the DRL and position lamp bulb socket connector receptacle.
8. Reconnect the battery negative cable.