Seat Adjuster - Installation

INSTALLATION






NOTE: If replacing the power or manual seat adjuster, remove the track stops from the front of both tracks. These stops need to be removed to snap into the same track locations on the new seat adjuster. If a stop is damaged, a new one should be ordered and installed.

NOTE: Take the proper precautions to protect the seat from cosmetic damage while performing this procedure.

NOTE: Power seat shown, manual seat fastening locations similar.

1. Transfer any parts onto power seat adjuster assembly (8) as necessary.
2. Install the seat back and seat cushion side shields Seat Back - Installation.
3. Position the seat cushion and pan (4) onto the power seat adjuster assembly.
4. Install the four seat cushion pan brackets (3) and bolts (2). Tighten the bolts securely.
5. Install the wire harness (5). Make sure all harness retainers are fully engaged to the adjuster assembly and seat cushion pan.
6. Connect the wire harness connectors (1, 6 and 7) to the three power seat motors.
7. Install the front seat Front Seat - Installation.
8. Reconnect the negative battery cable.
9. Verify seat operation.