Park and Turn Signal Bulb - Installation

BULB - PARK AND TURN SIGNAL - MK49

CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp, the socket or the lamp wiring.

NOTE: Although the park and turn signal lamp location is the same in both domestic and export market vehicles, the park lamp function is disabled and the amber bulb type is different in export market vehicles where that function is performed by the clear position lamp bulb.




Quad Halogen - Domestic



Bi-Halogen Projector - Export
1. Align the base of the bulb with the park and turn signal bulb socket (4).
2. Push the bulb straight into the socket until the base is firmly seated.
3. Reach behind the front lamp unit to access the bulb opening on the back of the lamp housing (1).
4. Align the socket and bulb with the keyed opening on the back of the housing.
5. Insert the socket and bulb into the housing until the socket is firmly seated.
6. Rotate the socket clockwise about 30 degrees to lock it into place.
7. Reconnect the Front End Module (FEM) wire harness connector to the park and turn signal bulb socket connector receptacle.
8. Reconnect the battery negative cable.