Rear

LAMP - MK49

NOTE: The rear fog lamp for MK74 models is integral to the tail, stop and turn lamp unit. . Tail Stop Turn Lamp - Installation

NOTE: The following procedure applies only to vehicles manufactured for certain export markets where rear fog lamps are optional or required equipment. In North American markets, a rear reflex (reflector) is installed in each rear fascia opening used for the rear fog lamps, but rear fog lamps are not available in vehicles manufactured for North American markets.





1. Position the rear fog lamp (2) close enough to the lamp opening of the rear fascia (1) to access and reconnect the rear fascia wire harness connector to the lamp socket on the back of the lamp housing.
2. Engage the retention feature integral to the inboard side of the lamp housing with the inboard side of the rear fascia opening for the lamp.
3. Using hand pressure, press firmly and evenly on the outboard side of the lamp until the snap feature integral to the outboard side of the lamp housing snaps into engagement with the rear fascia opening.
4. Reconnect the battery negative cable.