Rear

BULB - MK49

NOTE: The rear fog lamp for MK74 models is integral to the tail, stop and turn lamp unit. . Tail Stop Turn Lamp - Removal

NOTE: The following procedure applies only to vehicles manufactured for certain export markets where rear fog lamps are optional or required equipment. In North American markets, a rear reflex (reflector) is installed in each rear fascia opening used for the rear fog lamps, but rear fog lamps are not available in vehicles manufactured for North American markets.





1. Disconnect and isolate the battery negative cable.
2. Remove the rear fog lamp from the rear fascia. . Fog Lamp - Removal
3. Pull the lamp away from the rear fascia opening far enough to access and disconnect the rear fascia wire harness (1) connector (4) from the lamp socket (3) on the back of the lamp housing.
4. Firmly grasp the socket on the back of the lamp housing and rotate it counterclockwise about 30 degrees to unlock it.
5. Pull the socket and bulb straight out from the keyed opening in the lamp housing.
6. Pull the base of the bulb straight out of the socket.