Lower

INSTALLATION





1. Position the seat belt through the hole in the lower B-pillar trim.
2. Position the lower tabs (3) into the scuff plate (4) and seat the upper retaining clips (1) fully.





3. Install and tighten the screw (3) that secures the turning loop to the height adjuster. Tighten the screw to 40 Nm (30 ft. lbs.).





4. Position the seat belt (3) lower anchor to the mounting hole on the outboard side of the front seat cushion frame. Be certain that the seat belt webbing between the turning loop and the lower anchor is not twisted.
5. Install and tighten the screw (2) that secures the lower anchor to the seat. Tighten the screw to 51 Nm (37.5 ft. lbs.).
6. Install the lower anchor cover (1) onto the front seat cushion outboard side shield (4).