Third Row

THIRD ROW

WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts, buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the Chrysler Mopar(R) Parts Catalog.

NOTE: Third row seat belt and retractor units are only present on vehicles equipped with an optional third row seat.

1. Remove the third row seat from the vehicle.
2. Remove the screw (5) that secures the seat belt lower anchor (4) to the outboard rear corner of the third row seat support bracket (1).

3. Remove the two screws (4) that secure the seat belt escutcheon (1) to the top of the third row seat back (5).
4. Slide the seat belt webbing (2) through the slot (3) in the escutcheon to remove the escutcheon from the belt.
5. Remove the trim from the back and the top of the third row seat back frame.

6. Remove the through bolt (1) that secures the retainer bracket (2) to the top of the retractor pocket (4) on the front upper outboard corner of the seat back frame (3).
7. Remove the retractor retainer bracket from the top of the retractor pocket on the seat back frame.

8. Remove the screw (3) below the pull strap (1) from the back of the seat back frame (2) that secures the retractor.
9. Remove the third row seat belt and retractor as a unit from the top of the pocket on the front upper outboard corner of the seat back frame.