Front

FRONT

WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts, buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the Chrysler Mopar(R) Parts Catalog.





1. Adjust the front seat to its most forward position for easiest access to the front seat belt lower anchor cover (1) and the B-pillar trim.
2. Grasp the upper edge of the lower anchor cover and pull upward to unsnap it from the front seat cushion outboard side shield.
3. Remove the screw (2) that secures the lower anchor to the outboard side of the front seat cushion frame.





4. Firmly grasp the lower end of the turning loop trim cover on the upper B-pillar and pull it straight out to unsnap it from the height adjuster, then lift the bottom of the cover upward and pull outward to disengage the upper tabs from the adjuster.





5. Remove the screw (4) that secures the seat belt turning loop (5) to the height adjuster (2).
6. Remove the seat belt turning loop from the height adjuster.
7. Remove the upper trim (3) from the inside of the B-pillar (1). B-Pillar Trim Panel-Removal.
8. Remove the trim (8) from the lower B-pillar. B-Pillar Trim Panel-Removal.
9. Pull the front seat belt (6) turning loop and lower anchor through the seat belt opening in the lower B-pillar trim.
10. Remove the screw (7) that secures the retractor (9) lower bracket to the base of the inner B-pillar.
11. Remove the front seat belt and retractor from the vehicle as a unit.