Front Lamp Unit Bulb - Removal

BULB - PARK/TURN SIGNAL





1. Disconnect and isolate the battery negative cable.
2. Raise and support the vehicle.
3. Reach into the front wheel house ahead of the front wheel to unsnap and lift the cover over the access hole in the front of the wheel house splash shield.
4. Reach through the access hole in the splash shield to access the park/turn signal bulb socket (5) on the bottom of the front lamp unit housing.
5. Firmly grasp the socket on the bottom of the front lamp unit housing and rotate it counterclockwise about 30 degrees to unlock it.
6. Pull the socket and bulb straight out from the keyed opening in the housing.
7. Pull the base of the bulb straight out of the socket.