Electronic Vehicle Information Center - Installation

INSTALLATION





1. Position the steering wheel switch onto the switch bezel aligning the switch tabs (1) with the bezel retainers (2).
2. Press the switch into the bezel until the switch is held in place by all four retainers.





3. Position the switch and bezel assembly (3) over the steering wheel and connect the switch electrical connector.
4. Align the switch bezel tab (1) with the slot in the steering wheel and press the switch and bezel assembly (3) into the steering wheel until it is secured in place.
5. Install the driver airbag, Driver Air Bag - Installation.
6. Do not reconnect the battery negative cable at this time. The Supplemental Restraint System (SRS) verification test procedure should be performed following service of any SRS component. . Supplemental Restraints Verification Test
7. Connect the battery negative cable.