Remote Switch: Testing and Inspection

REMOTE SWITCHES

Any diagnosis of the Audio system should begin with the use of a scan tool and the appropriate Diagnostic Service information.

Refer to the appropriate wiring information.

WARNING: Disable the airbag system before attempting any steering wheel, steering column, seat belt tensioner, side airbag or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable. Wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury.





1. Remove the remote radio switch(es) (1) and (2) from the steering wheel Remote Radio Switches - Removal.
2. Use an ohmmeter to check the switch resistances as shown in the Remote Radio Switch test table. If the remote radio switch resistances are not as indicated, replace the inoperative switch.

REMOTE RADIO SWITCH TEST