Amplifier - Installation

INSTALLATION






WARNING: On vehicles equipped with airbags, disable the supplemental restraint system before attempting any steering wheel, steering column, driver airbag, passenger airbag, seat belt tensioner, side curtain airbag, front impact sensor, side impact sensor, or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure to take the proper precautions could result in accidental airbag deployment and possible personal injury.

1. Position the amplifier into place.
2. Install and tighten the mounting fasteners.
3. Connect the two wire harness connectors.
4. Install the left quarter trim panel.
5. Connect the battery negative cable.