Instrument Panel Antenna Cable - Removal

REMOVAL

WARNING: Disable the airbag system before attempting any steering wheel, steering column, seat belt tensioner, side airbag or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable. Wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury.

DOMESTIC





1. Disconnect and isolate the battery negative cable.
2. Remove radio Radio - Removal.

CAUTION: Pulling the antenna cable straight out of the radio without pulling on the locking antenna connector could damage the cable or radio.

3. Disconnect the antenna cable by pulling the locking antenna connector (2) away from the radio (1).





4. Remove the glove box.
5. Remove instrument panel side panel.
6. Disconnect instrument panel cable (1) from antenna body and cable (2).





7. Remove the antenna retaining straps and remove antenna cable (4).

EXPORT

WARNING: Disable the airbag system before attempting any steering wheel, steering column, seat belt tensioner, side airbag or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable. Wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury.





1. Disconnect and isolate the battery negative cable.
2. Remove the instrument panel Instrument Panel - Removal.

CAUTION: Pulling the antenna cable straight out of the radio without pulling on the locking antenna connector could damage the cable or radio.

3. Disconnect the antenna cable by pulling the locking antenna connector (2) away from the radio (1).





4. Disengage each of the retainers that secure the cable (2) to the instrument panel and remove cable.