B210C-16

B210C-16-BATTERY VOLTAGE INPUT-CIRCUIT VOLTAGE BELOW THRESHOLD

For a complete wiring diagram, refer to the Wiring Information Electrical Diagrams.

- When Monitored:
While the vehicle is in reverse for speeds less than 10 mph (16km/h).

- Set Condition:
Park Assist Module supply voltage less than 6.5 volts.





1. CHECK FOR ACTIVE DTC
1. Turn the ignition on.
2. With the scan tool, read Park Assist Module DTCs.

Is this DTC active?

Yes

- Go To 2

No

- The condition that caused this code to set is not present at this time. Check for an intermittent condition by inspecting the related wiring harness for chafed, pierced, pinched, and partially broken wires. Also inspect the related connectors for broken, bent, pushed out, spread, corroded, or contaminated terminals.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

2. VERIFY OPERATION OF THE VEHICLE CHARGING SYSTEM

NOTE: Troubleshoot any PCM/ECM charging/cranking DTCs before proceeding.

NOTE: Make sure the battery is fully charged.

Are any charging system DTCs present?

Yes

- For gas engine applications, Testing and Inspection Perform the appropriate charging system or battery diagnostic procedure.

No

- Replace the Park Assist Module.
- Perform the BODY VERIFICATION TEST. Body Verification Test.