4.2L, Vehicles With: Supercharger

4.2L, Vehicles With: Supercharger

Manifold Absolute Pressure (MAP) Sensor

Removal

All vehicles






1. Remove the engine cover.
2. Remove the cowl vent screen.






3. NOTE:
- Left-hand shown, right-hand similar.
- Remove the engine compartment supports.






4. Loosen the throttle body intake pipe retaining clip.






5. Detach the air filter outlet pipe






6. Remove the throttle body intake pipe.
- Detach the throttle body intake pipe.
- Remove the throttle body intake pipe.






7. NOTE:
- Right-hand drive vehicles shown, left-hand drive vehicles similar.
- Remove the engine compartment outer panel insulation.

Right-hand drive vehicles






1. Remove the engine compartment outer panel.

Left-hand drive vehicles






1. Remove the engine compartment outer access panel.

All vehicles






1. NOTE:
- Right-hand drive vehicles shown, left-hand drive vehicles similar.
- Remove the cabin air filter.
- Detach the cabin air filter.
- Remove the cabin air filter.






2. NOTE:
- Right-hand drive vehicles shown, left-hand drive vehicles similar.
- Remove the cabin filter housing.
- Remove the cabin filter housing retaining nuts.
- Remove the cabin filter housing.






3. NOTE:
- Right-hand drive vehicles shown, left-hand drive vehicles similar.
- Detach the engine compartment outer panel.
- Remove the engine compartment outer panel retaining bolt.
- Detach the engine compartment outer panel.






4. Remove the engine compartment outer panel.
- Detach the hood release cable.






5. Remove the engine compartment supports spacing plate.






6. Detach the engine compartment inner panel insulation.






7. NOTE:
- Right-hand drive vehicles shown, left-hand drive vehicles similar.
- Remove the left-hand engine compartment inner panel.






8. NOTE:
- Left-hand drive vehicles shown, right-hand drive vehicles similar.
- Remove the right-hand engine compartment inner panel.






9. Disconnect the manifold absolute pressure (MAP) sensor electrical connector.






10. Remove the MAP sensor.


Installation






1. To install, reverse the removal procedure.
- Tighten to 10 Nm.






2. NOTE:
- Left-hand shown, right-hand similar.
- Tighten to 25 Nm.