Pinpoint Test G295394p1: DTC B1342; Control Module Failure

PINPOINT TEST G295394p1: DTC B1342; CONTROL MODULE FAILURE

G295394t1: CHECK THE POWER SUPPLY TO THE EPB CONTROL MODULE
1. Disconnect the EPB control module electrical connector, CR50.
2. Measure the voltage between CR50, pin 01 (NW) and GROUND.

^ Is the voltage less than 10 volts?

-> Yes REPAIR the circuit between the EPB control module and battery. This circuit includes the battery junction box (fuse 32). For additional information, refer to Vehicle/Diagrams. CLEAR the DTC. TEST the system for normal operation.

-> No GO to Pinpoint Test G295394t2.

G295394t2: CHECK THE GROUND TO THE EPB CONTROL MODULE
1. Measure the resistance between CR50, pin 04 (B) and GROUND.

^ Is the resistance greater than 5 ohms?

-> Yes REPAIR the high resistance circuit. For additional information, refer to Vehicle/Diagrams. CLEAR the DTC. TEST the system for normal operation.

-> No Contact dealer technical support for advice on possible EPB control module failure.