Automatic Window Control Switch

Automatic Window Control Switch (86.65.97)

Removal

1. Turn ignition key to position II.
2. Motor door glass to fully raised position.
3. Turn ignition key to position O.
4. Remove battery cover and disconnect ground cable from battery terminal.
5. Remove door casing for access.
6. Remove door primary water shedder.
7. Position PVC secondary water shedder for access.
8. Remove door latch assembly from vehicle.
9. Slacken and remove latch assembly cover securing screw.







10. Release cover to latch inner locating boss and remove cover.







11. Release door glass drop switch securing tangs and remove switch from latch assembly.







12. Remove and discard switch harness securing tape
13. Remove harness multiplug pin protector and using special tool MS.1540, release switch terminal pins from multipug.

Installation

1. Fit and fully seat switch terminal pins in harness multiplug and fit terminal pin protector.
2. Fit door glass drop switch to latch assembly, ensuring that both tangs are fully seated.







3. Secure switch harness with suitable tape.
4. Fit cover to latch assembly.
- Position cover over latch assembly, ensuring that internal boss locates correctly in latch housing.
- Fit and tighten cover securing screw.







5. Fit latch assembly to door.
6. Connect ground cable to battery terminal and fit battery cover.