Downshift Switch: Adjustments

KICKDOWN SWITCH - CHECK AND ADJUST

1. Ensure that the throttle cable is correctly adjusted.
2. Refer to the PDU User Guide for relevant software - 1040.
3. With PDU connected, running and the message 'EXISTING COMPONENTS TO BE TESTED YES NO' displayed:
Select YES.
Select ENTER.
Follow the messages given on the screen.
4. Press ENTER on the PDU screen.





5. Following the PDU instructions:
Push the throttle pedal until light contact is made with the kickdown switch and hold in this position.
Press ENTER on the display. Note the percentage throttle open data (displayed as a bar graph).

NOTE: Ensure that contact with the switch does not result in movement of the switch.

Release the throttle pedal.
6. If the target 90% throttle open specification is NOT achieved the switch must be adjusted as follows.





7. Disconnect the kickdown switch multiplug. Move the carpet for access.





8. Adjust the kickdown switch to the value as defined in step 6.
Rotate the switch in the required direction.
9. Verify the setting.
10. With the PDU instructions completed, connect the kickdown switch multiplug.