Air Bag Control Module: Service and Repair

WARNING: BEFORE ANY AIRBAG/SRS SERVICE IS PERFORMED, PLEASE REVIEW SERVICE PRECAUTIONS. Service Precautions

Removal
1. Turn ignition key to position II, power passenger's seat fully rearwards and turn ignition key to position 0.
2. Remove battery cover and disconnect ground cable from battery terminal. Service and Repair

WARNING: BEFORE ANY AIRBAG/SRS SERVICE IS PERFORMED, AT LEAST ONE MINUTE MUST ELAPSE AFTER DISCONNECTION OF THE BATTERY POSITIVE CABLE, TO ALLOW DISSIPATION OF BACK-UP POWER SUPPLY ENERGY.

3. Remove glove box. Service and Repair
4. Remove body processor module.





5. Remove footwell lamp and mounting bracket.
1. Slacken and remove screw securing footwell lamp mounting bracket to the air conditioning duct.
2. Disconnect footwell lamp multiplug.
3. Remove footwell lamp and bracket.





6. Detach fascia harness fasteners from fascia RH end panel and reposition harness for access.





7. Disconnect air bag control module harness multiplugs.





8. Remove fascia harness to cabin harness multiplugs from mounting bracket and reposition for access.
9. Remove air bag control module from fascia.
- Slacken and remove the two air bag module mounting bracket to fascia outer securing bolts.
- Slacken and remove module/fascia securing bolt.
- Slacken and remove air bag control module upper securing bolt.
- Remove air bag control module from vehicle.


Installation
1. Fit air bag control module.
- Position air bag module at fascia.
- Fit but do not tighten the two module mounting bracket outer securing bolts.
- Fit but do not tighten the module/fascia securing bolt.
- Fit and tighten module upper securing bolt.
- Tighten all module securing bolts.
2. Connect air bag control module.
- Connect module harness multiplugs.
- Position and fit fascia to cabin harness multiplugs to mounting bracket.
3. Fit footwell lamp.
- Align and fit footwell outlet duct.
- Position footwell lamp mounting bracket and fit and tighten securing screws.
- Connect footwell lamp harness multiplug.
4. Fit body processor module.
5. Fit glove box.
6. Connect ground cable to battery terminal and fit battery cover. Service and Repair