| Exhaust System Settings | Intermediate Muffler - Rear Inside Edge to Muffler to Rear Suspension A-Frame | 116 mm |
| Tailpipe to Bumper Aperture - Vertical | 25 - 35 mm |
| Tailpipe Trim Position - Vertical (Permissible Variation LH to RH) | 0 - 6 mm |
| Tailpipe Trim Position - Horizontal (Permissible Variation LH to RH) | 0 - 6 mm |
| Tailpipe Trim Surface to Inside of Bumper Aperture | 35 - 45 mm |
| Tightening Specifications | Nut - Downpipe to Exhaust Manifold | 14 - 18 Newton Meter (Nm) |
| Bolt - Downpipe to Bracket | 39 - 51 Newton Meter (Nm) |
| Torca Clamp Assembly | 60 - 80 Newton Meter (Nm) |
| Tie Strap Fixings | 22 - 28 Newton Meter (Nm) |
| Bolt - Grass Shield Fixings (Japanese Market Only) | 8.5 - 11.5 Newton Meter (Nm) |
| Bolt - Over-Axle Mounting Cradle to Rear Suspension A-Frame | 22 - 28 Newton Meter (Nm) |
| Bolt - Tailpipe Mounting Rubber Upper Support to Body | 17 - 23 Newton Meter (Nm) |
| Oxygen Sensor to Downpipe | 40 - 50 Newton Meter (Nm) |