Engine/Wheels - Revised Dipstick/Inflation Adapters
204-13DATE: 11/00
V8 XJ Series/XK
MODEL:
1997 MY-ON XK Range
1998 MY-ON V8 XJ Series
VIN:
001001-ON
812256-ON
R-Performance Wheel Kits - Revised Engine Oil Dipstick/increased Oil Capacity - Tire Inflation Adapters
Issue:
This Technical bulletin outlines some unique aspects of the R-Performance Accessory Wheel Kits. The kits provide new engine oil dipsticks and special adapters for inflating the tires.
Action:
DIPSTICKS FOR 1997-1999 MY ENGINES
Once the larger R-Performance wheel kits have been installed, some customers may drive their car in a manner that may result in heavy cornering. This could cause oil to surge around the engine and result in reduced lubrication. Therefore, as a cautionary measure, an extra liter of oil must be added to the vehicle to ensure optimum performance. Shorter oil dipsticks (part no. MXD 6249AA and XR8 2806) depending on engine type, are included in the R-Performance Accessory Wheel Kits to indicate the higher oil level correctly.
The installation instructions indicate which dipstick to use depending on vehicle VIN.
Note:
Once the revised oil dipstick has been installed (see Workshop Manual JTIS CD ROM, section 303-01), advise customers that the engine now requires an additional quart of engine oil above that stated in the owner handbook to achieve the correct oil level.
After the new oil dipstick has been installed, discard the old oil dipstick that was originally supplied with the engine.
The new dipstick is not required on vehicles manufactured after the introduction of 2000 Model Year.
INFLATION ADAPTERS - ALL WHEELS
The R-Performance wheels have tire valves hidden behind a dust cap in the row of fasteners around the circumference of the wheel. The dust cap is located near the BBS letters cast into the wheel and can be identified by it's single slot. The inflation adapter (Illustration 1) and a T-shaped tool for removing the dust cap are stored in a small pouch in the vehicle.
To check inflation pressure, remove the dust cap and screw in the inflation adapter (Illustration 2). After checking/inflating, remove the adapter and store it in the vehicle. Screw in the dust cap.
WHEEL/TIRE SPECIFICATIONS
Parts Information
Warranty Information
This Bulletin is issued for information only.