Cowl Vent Screen

Cowl Vent Screen (76.10.01)

Removal

1. Open hood and fit fender covers.
2. Remove wiper arm and blade assemblies.
3. Remove plenum chamber cover.

4. NOTE: Driver side water deflector is captive to throttle cable.

Slacken and remove bolts securing plenum chamber water deflectors to BIW and remove passenger side deflector from vehicle.







5. Rotate throttle quadrant to fully open position and disconnect throttle inner cable nipple from quadrant.







6. Cut through and discard tie strap securing throttle cable and adjuster to abutment bracket and lift cable and adjuster clear of bracket.







7. Pass throttle cable through plenum closing panel grommet.







8. Pass throttle cable through driver side water deflector and remove deflector.







9. NOTE: This step is not applicable to N/A vehicles from 1999 Model Year onwards.

Disconnect both ignition amplifier harness multiplugs.







10. Slacken and remove plenum chamber closing panel to BIW securing nuts and remove panel from vehicle.







11. Remove nuts securing ignition amplifiers to closing panel and remove amplifiers from panel.







Installation

1. Position ignition amplifiers on closing plate and fit and tighten securing nuts.
2. Fit closing plate to BIW ensuring that lower clips locate correctly on body flange.







3. Fit and tighten closing plate to BIW securing nuts.







4. NOTE: This step is not applicable to N/A vehicles from 1999 Model Year onwards.

Connect both ignition amplifier harness multiplugs.







5. Pass throttle cable through driver side water deflector.







6. Pass throttle cable through closing plate grommet.







7. Position throttle quadrant to fully open position and fit throttle cable inner to quadrant ensuring that nipple fully seats in slot.







8. Release throttle quadrant and fit and fully seat throttle cable adjuster in abutment bracket.







9. Check and as necessary adjust throttle cable.
10. Using new tie strap, secure throttle cable adjuster in abutment bracket.
11. Position plenum water deflectors and fit and tighten securing bolts.







12. Fit plenum chamber cover.
13. Fit wiper arm and blade assemblies.
14. Remove fender covers and close hood.