Installation

Installation
1. Position latch cover on header rail and fit and tighten center securing screws.
2. Lift RH edge of header seal for access and fit and tighten the latch cover RH securing screw.
3. Fit and fully seat new retaining stud to RH end of header seal.
4. Lift LH edge of header seal for access and fit and tighten the latch cover LH securing screw.
5. Fit and fully seat new retaining stud to LH end of header seal.
6. Ensuring that microphone flying lead is routed towards harness multiplug, position trim finisher on header rail and secure with new fir tree fastener.
7. Fit 'A' post upper trim finishers.
8. Fit illuminated sun visors.
9. Fit illuminated sun-visor retention bezels.
10. Connect microphone flying lead to harness.
11. Fit roof console. See 'Interior Trim, Console.' Service and Repair
12. Fit ground cable to battery terminal and fit battery cover. Refer to 'Starting and Charging, Battery.' Service and Repair
13. Power covertible top to fully raised position